Simplex roller chain is mean of single strand industrial roller chains which are functioned in the range of ¾” to 2” in BSS and ANSI. Duplex Roller chain is a mean of double strand industrial roller chain which is functioned in the range of ¾” to 2” in BSS and ANSI. Triplex roller chain is a mean of double strand industrial roller chain which is functioned in the range of ¾” to 2” in BSS and ANSI. Chains without roller are frequently used for handling static or intermittent loading in forklifts and other applications where rollers are not required. Leaf Chains - Used where greater tensile strength than roller chains and run over the sheaves rather than sprockets, mostly used as accouter, Weight for machine tools, elevator and open door, forklift truck masts, spinning frames, and similar lifting or balancing applications.
[...] 10) If the hardness is not correct and is above limits, then load the lot, in the second Heat Treatment Chamber for the Tempering process or hardness lowering process. 11) Set the time and Heat parameters as per the instructions of Management Representative. 12) After the time of the process is finished, unload the lot and check for the hardness on a sample lot of 5 pieces. 13) If it is either correct or lower than required then send the lot for the next process. 14) If it is not then reload it. 15) Send the pieces to the next stage i.e. Barreling. [...]
[...] 11) Set the time and Heat parameters as per the instructions of Management Representative 12) After the time of the process is finished, unload the lot and check for the hardness on a sample lot of 5 pieces. 13) If it is either correct or lower than required then send the lot for the next process. 14) If it is not then reload it. Barreling: Barreling is a process where the lot that is removed out of the Heat Treatment Chamber is cleaned so that the shining of the pieces surfaces out. [...]
[...] Chain Manufacturing process in a typical chain manufacturing industry MACHINERY BASED PROCESSES: Refer to the instructions of the Management Representative for the loading of the dies for the entire individual parts i.e. Job flats, Tube Materials and Pin Material and also for the working of the different machines. Refer to the work instructions of the respective processes for all the individual parts, to carry out the whole work. Ask the Management representative for all the settings during the processes, wherever required, in the above processes, and continue with the same till further instructions. [...]
[...] There are three categories of raw material and so the complete process is divided into the individual process of these three materials respectively and then the assembly and interlinking of these materials. The three raw materials are as follows: Job Flat Tube Material Pin Material. Job Flat: Job Flat is normally available in Coils or Rolls. For some special applications and product categories they are also sourced as plain bars. Job flats are of different thickness and different widths. The following are the different steps in the process of the job Flat. [...]
[...] 13) After the time of the process is finished, unload the lot and check for the hardness on a sample lot of 5 pieces. 14) If it is either correct or lower than required then send the lot for the next process. 15) If it is not then reload it. 16) Send the pieces to the next stage i.e. Barreling. Barreling: Barreling is a process where the lot that is removed out of Heat Treatment Chamber is cleaned so that the shining of the pieces surfaces out. [...]
APA Style reference
For your bibliographyOnline reading
with our online readerContent validated
by our reading committee